ICCD SMARTCARD DRIVER

The response APDU begins with this command and is to continue 02h: The value for bReserved is given in the tables. It is not the result of an OUT message or request received from the host. Shall be in the range from 1 to In order to save bandwidth, the time interval should not be less than 10ms. The recommended value is

Uploader: Tozragore
Date Added: 3 January 2013
File Size: 46.32 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 79728
Price: Free* [*Free Regsitration Required]

There are two possible implementations for control transfers, version A and version B. Control transfer mode is supported by two versions, version A and version B. The time interval is driver dependent. Its size is 0, 1 or 3 bytes.

These definitions are intended to clarify the discussions that follow. Returns the ATR in the data stage. It must be different from the Bulk-IN endpoint address. Instead, it uses class-specific protocols on the interface level. The response APDU begins smartcwrd ends in this command 01h: The value for bReserved shall be 00h. For correct operation of the interrupt request, the following conditions shall apply: It does not contain class-specific information.

Last Drivers  MIOMAP C250 DRIVER

For extended wmartcard APDUs: In case of a failure, an error code will be returned. The value is given in units of 10ms e.

Zero-based value identifying the index in the array of concurrent interfaces supported by this configuration. For the parameters, the following general rules shall apply: P1, P2 INS parameter of a command header.

The response APDU begins with this iccv and is to continue 02h: The maximum number of bytes present in this body. The maximum number of bytes expected in the data field of the response APDU. Size of expected data to be returned icxd the bulk-IN endpoint. P3 INS parameter of a command header.

Smart Card ICCD version |

NOTE The first condition allows the host to detect an unresponsive card. The sequence starts with the ICC already powered. Not relevant, fixed to 00h for legacy reason 6 bSeq 1 FFh Sequence number for command. For example, a bit integer stored in little endian format places the least significant byte at the lower address and the most significant byte at the next address.

Last Drivers  IBM X31 ETHERNET CONTROLLER DRIVER

README · master · Ludovic Rousseau / CCID · GitLab

The host may abort any transfer by sending an IN-token prematurely. The value of wLength shall be greater than or equal to 4. These requests provide sartcard same services to the application layer as bulk transfers. It’s a community-based project which helps to repair anything.

BIFIT BIFIT ICCD Smart Card Reader how to download and install the driver

Used interchangeably with Smart Card. The following tables give the values and the parameters for each of the class specific requests and describe the data that is transferred between host and USB-ICC. For example, bus enumeration and suspend shall not cause any transition. Indicates if the response is complete, to be continued or if the command APDU can continue Size of abData field of this message 00h: The sequence starts with the ICC powered off.